sjon bedankt voor jouw antwoord. Over die carburateurs...ik ben verre van een specialist maar heb wel veel gelezen. Mijn venturis zijn 36mm en op de engelse fora zeggen ze.
Heres the way to calculate the correct carb sizes for the job,
Venture size = √ (0.6 x Inlet valve Diameter^2 x Number of inlet valves / 0.85)
just to let you know 0.6 is an estimated flow coefficient, i would expect it to be that being ported and polished,,, may be 0.5 if not,, and if you
think you have an F1 head which you wont 0.7
the 0.85 is effective area dont worry about the its just a percent!
For top end power round up to the nearest mm
For bottom end round down 2 mm
for example 6n 16v
√ 0.6 x 29.5^2 x 2 / 0.85 = 35.05mm
Hier gaan jullie veel sneller voor grotere venturi's...wat zijn de voor en nadelen?