First thanx for reading this.
I´ts been a while sins the last update but better late then never ...
Hello
Now, the chassi update has begun.
first we dissmounted all at the rear, beam wishbone etc.
Empty...
It´s always more work..
On this pic, you can see two other taction arms that we was thingking of using but no, we will make a new set with unibolts...
time to start up the lathe, had to produce this..
Can anyone see what this is?
When we found the rigth pivot point for the rear beam, I could start with the front end.
Then to the fun parts. :)Rear beam modification.
We will build a trailingarm setup.
Man in action....
One done .
Did make a new set of shorter steering arms.
These will give us quicker steering respons.
Thomas